Exothermic Welding Accessories

When making a copper wire connection of Ground rod or other metal connection, place the Welding powder into the graphite mould. Just ignite to start the Welding process. The result will be clean and smooth connection surface. It is also applicable for other metal such as: Iron, Galvanized Steel, Railway track, Cast Iron, Bronze, and Brass. It can be used in various applications to have the certainly good connections in work. Such as Lightning and Surge Protection, Grounding in Electrical Work, Railway Construction, Cathodic Protection.
The connection mould is designed to last for an average of 60 to 100 connections. This will vary according to the care given the mould during use.Graphite mould is made of high quality graphite suitable for high quality Weldinging work and can be used for several times.
Features of Graphite Mould:
- Dimensional accuracy as per the customers demand.
- High quality Graphite which ensures Longer Life.

Steel Metal Disk Steel discs are very important. The disc acts timing device to allow the Exothermic Weld Powder to heat to proper temperature. Steel Disk is designed to contain the exothermic reaction to the upper crucible of a mold until the reaction is complete and ready to Welding. One Metal is must for every shot

It is used to clean the objects to be Weld.
We recommend One Slag Tool for Every 50 Joints

Graphite absorbs moisture from weather. So there is a need for propane torch to dry out the inside of the mould thoroughly on both sides, therefore heating the mold to approximately 250 degrees Fahrenheit
We recommend using one Flame torch for Every 100 Joint and than use the refiling.

Gloves is required for safety purpose as the Exothermic Weld Powder melts at more than 1400 degree Celcius.
We recommend a Pair of Gloves for Every 100 Joints

It is designed with the advantages of safety and convenience. It is used to ignite Starting Powder in order to result in exothermic reaction.
We recommend one Flint Gun for every 100 Shots

For most connections involving lugs, cable or rectangular bus, exothermic handle clamps are used.
These will fit 90% of all standard exothermic molds. Normally we recommend One Handle for every two moulds.These are manufactured by the professionals using high quality raw material. These Mold Handle Clamp conform their adherence with the industry standards.
Features of Graphite Mould Handle Universal Clamp:
- Light in weight (Nearly 1.5 to 2.0 Kg)
- Handy in nature
- Rust-proof
- Tare used for two part molds

It is used to remove the metal Scrap from Mould after the Welding Process is done.
We recommend One Slag Tool for Every 100 Joints

Two Brush Required:
1) Soft Brush – Its used to Clean Mould Welding Cavity because its shape is very sensitive and there should not be any damage while using Brush, so we recommend to use Soft
2) Hard Brush – Its used to clean other section of Mould
We recommend a Pair of Brush for 25 Connection

Sun Glass is Using For Eye Safety

We Recommend Using Sun Glass For Every 100 Joint.